perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Super nice! Good to have a manual in digital format.
Text excerpt from page 7 (click to view)
First Use
Batteries � Remote Control
To insert or replace the batteries press where the arrow is imprinted. Slide the battery compartment cover downwards and remove it. Insert batteries of type Alkaline Manganese LR 03 (AAA) and make sure + and � poles are the right way round.
Connection
Power supply Connect the TV set to a 230V/50�60 Hertz socket. Antennas Connect your antenna or cable system to the VHF/UHF antenna socket. Plug the antenna plug which emerges above the antenna socket in the antenna socket for the PIP tuner. If the set is equipped with one or two satellite tuners, connect the Sat antennae to the SAT sockets (see fig. page 5).
Switching on for the first time
The TV�s automatic programming is activated the first time you switch it on. First you have to select the menu language for your TV set. Then specify which antenna you have connected to your TV and in which country you are operating it. Follow the menus and then start the automatic programming. Select the settings with the arrows on the rings ... ... confirm your settings with OK. You then come to the next menu ...
+
+
Switching on
OK
Then push the cover back up. The remote control display appears only when you press a button. If you no longer operate it, the display switches off again after 20 seconds. Replace the batteries when the �Batteries empty� can be seen in the remote control display. Notes on battery disposal: The original batteries do not contain any pollutants such as cadmium, lead and mercury. Used batteries do not belong in the domestic waste. They must be taken to the appropriate collection points according to the national laws. Ask your dealer.
The TV�s On/Off button is located behind the cover of the control panel. Press here to open the control panel ...
i
... Press this key if you need information about the settings.
Press the On/Off key so that it clicks into position.
§
Push both sides of the control panel together to close it.
Use the pre-programmed satellite stations if necessary, otherwise they will be erased. Once you have answered all the questions for the automatic programming your settings will be displayed. Check whether everything is correct. Then start the automatic programming with the OK key. The TV searches for and sorts all programmes which can received by your antenna system. You see the programme preview after the automatic programming. You can repeat switching on for the first time at any time, e.g. after moving house or retrofitting satellite tuners. Call the index in the Main Information (i-key). Then select the index item �First installation repeat�. Then start �First time switching on� with OK.
